Selecting number of anchors and tags.

Moderator: mikeh9

mikeh9
Site Admin
Posts: 29
Joined: Thu Mar 17, 2016 4:39 pm

Selecting number of anchors and tags.

Postby mikeh9 » Fri Aug 18, 2017 5:03 pm

1. Click on the Settings tab.
2. Select the number of anchors. Maximum is 8.
3. Select the number of tags. Maximum is 16.
4. Select the transmission power.
    0 is for automatic
    1 is the lowest power
    6 is the highest power
5. Depending on the distance between the anchors, you may need to select a higher power level.
cong
Posts: 22
Joined: Tue Aug 15, 2017 8:15 pm

Re: Selecting number of anchors and tags.

Postby cong » Tue Nov 21, 2017 8:40 pm

Notice:
The Master Anchor, which is labeled Anchor #1, has a device ID of Anchor0 on USBTraq interface screen.
Tag device IDs are 1 less than the labeled number. Ex: labeled Tag#1 has a device ID of 0

Selecting number of Anchors and tags
1. On USBTraq interface screen, select Setting tab.
Setting USBTraq.png
Setting USBTraq.png (114.3 KiB) Viewed 1262 times

2. On System section:
    a. Select Number of Anchors. Maximum is 8
    b. Select Number of Tags. Maximum is 16
    c. Select Transmission power as following:
      i. 0 for automatic power
      ii. 1 is the lowest power
      iii.6 is the highest power
Notice: Depending on the distance between the anchors, you may need to select a higher power level.

Return to “Configure Master Anchor”

Who is online

Users browsing this forum: No registered users and 1 guest