Re: Enable / Disable Magnetometer

Moderator: mikeh9

Posts: 22
Joined: Tue Aug 15, 2017 8:15 pm

Re: Enable / Disable Magnetometer

Postby cong » Wed Nov 22, 2017 11:00 pm

The Master Anchor, which is labeled Anchor #1, has a device ID of Anchor0 on USBTraq interface screen.
Tag device IDs are 1 less than the labeled number. Ex: labeled Tag#1 has a device ID of 0

Enable/Disable Magnetometor:
1. On USBTraq interface screen, select Setting tab.
2. Under Using Power Level section, click on Magnetometer Enabled.
3. When the magnetometer is enabled, the orientation will follow the compass North direction.
Enable-Disable Magnetometor USBTraq.png
Enable-Disable Magnetometor USBTraq.png (117.66 KiB) Viewed 1193 times

Return to “Configure Tag”

Who is online

Users browsing this forum: No registered users and 0 guests