Select Filter Number

Moderator: mikeh9

mikeh9
Site Admin
Posts: 29
Joined: Thu Mar 17, 2016 4:39 pm

Select Filter Number

Postby mikeh9 » Fri Sep 08, 2017 7:49 pm

Information will be found here soon.
cong
Posts: 22
Joined: Tue Aug 15, 2017 8:15 pm

Re: Select Filter Number

Postby cong » Fri Dec 22, 2017 7:08 am

Setting Filter Number for Tag
Once connect USBTraq to a Tag, you make select the filter method from the following options:
0- No filtering
1- Tags uses any anchors available. Minimum of anchors is 3 and the maximum of anchors is 8
3- Tag automatically picks 4 anchors that are the closest and continues to use those 4 anchors until one of them are no longer available. Then, the Tag will search for the next 4 anchors to use. The positions being calculated will be more consistent.
7- Used for tag calibration
8- Applies 250 pt moving average. Useful in applications that have lots of noise, but can tolerate lag.
9- Tag required valid distances to all anchors being used. The positions being calculated will be more consistent.
10- Just like method 9, but when the tag is not moving, no extra filtering will be applied.

Return to “Configure Tag”

Who is online

Users browsing this forum: No registered users and 1 guest